<div dir="ltr"><div><div><div><div><div><div><div><div>Dear EEG Lab list,<br><br></div>we are using a CHEPS thermode on a Medoc Main Station (<a href="https://medoc-web.com/products/pathway-model-cheps/">https://medoc-web.com/products/pathway-model-cheps/</a>) and a 64 Channel g.HIamp from gtec with active electrodes (basically electrodes with an amplifier in it). I am currently measuring heat evoked potentials, so nothing really fancy.<br><br></div>When doing the eeg recordings, I am experiencing a strange behaviour I can't make heads and tails of. I am usually looking at an unreferenced EEG signal while recoding as we are doing and average referecing in the post-processing. Here is a screenshot of how the eeg looks _every_ time a trigger signal (CHEPS) of 51°C is applied to a subject (non-filtered, non referenced)<br><a href="https://imgur.com/ANxIPQb">https://imgur.com/ANxIPQb</a><br><br></div>Filtering the data doesn't make it better (notch, bandpass), just smoother, re-referencing (either average or earlobe, doesn't matter) completly removes the very significant pattern and results in a what I would call "normal" EEG.<br><br></div>I am especially worried about the very "flat sinus wave" after the trigger (trigger = peak temperature of 51 °C). When I measure an eeg without a subject and start the CHEPS electrode, no such pattern is seen. What I haven't tried is measuring and EEG on a subject, start the CHEPS measurement without the electrode applied to the subject to see if this pattern reoccurs, but I will try that. The only physical connection between EEG and CHEPS station is a +5V trigger cable which hopefully doesn't impose any electrical disturbances.<br><br></div>I just want to know if I need to be worried about the flat sinus wave after the trigger. I know that it is gone after the re-referencing, but I am not sure if there is any electrical interference I am currently not paying attention to. Also the pattern before the trigger always looks exactly the same (up, down, up, down and then flat sinus wave)!!! As I am looking for potentials in a 5-10 microvolt range I just want to be extra cautious, and the unreferenced signal produces this pattern in the millivolt-range, that's why I am a bit worried.<br><br></div>I am hoping this is the "normal" physical response of a subject in a heat evoked potential, but I just wanted to double check with somebody who has done evoked potentials before to rule out any interference here.<br><br></div>Thank you so much!<br></div>Malte<br><div><div><div><div><br><br></div></div></div></div></div>