[Eeglablist] Parameters in STUDY
mmiyakoshi at ucsd.edu
Mon Sep 15 18:12:55 PDT 2014
I've never used channel STUDY so I don't know if there is a problem on this
plotting function... could you check it?
On Wed, Sep 3, 2014 at 2:47 PM, Eric HG <erichg2013 at gmail.com> wrote:
> Hi all,
> I have been using the STUDY to get the power differences from pre/post in
> three different condition (3x2 design). I have been using parametric
> statistics (p-value at 0.05) and corrected for multiple corrections using
> FDR and I want to look at spectral power at different bands.
> However, I'm confused about spectrum plotting options and multiple
> channels selection under parameters when clicking 'plot channel measures'.
> I get different results depending on whether I specify the frequency I
> want to look at under 'spectrum plotting options' --> 'frequency' and
> 'multiple channels selection' --> 'plot topography at freq. (Hz)'. Am I
> doing something wrong?
> Best regards,
> Eeglablist page: http://sccn.ucsd.edu/eeglab/eeglabmail.html
> To unsubscribe, send an empty email to
> eeglablist-unsubscribe at sccn.ucsd.edu
> For digest mode, send an email with the subject "set digest mime" to
> eeglablist-request at sccn.ucsd.edu
Swartz Center for Computational Neuroscience
Institute for Neural Computation, University of California San Diego
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the eeglablist