[Eeglablist] Issue with 50 Hz
mmiyakoshi at ucsd.edu
Wed Dec 16 11:33:22 PST 2015
CleanLine does not guarantee to remove the line noise completely,
especially if the level is very high--I don't know why it behaves like
this, but on this point CleanLine is different from notch filter (notch
filter never fail to dig a hole in the spectrum curve). If you find out
that it unfortunately did not work well, you should either apply notch
filter or give up above the line frequency. I updated my pipeline wiki.
On Mon, Dec 14, 2015 at 11:06 PM, jason roger <jasonroger8 at gmail.com> wrote:
> Hi everyone,
> I processed my EEG data using Makoto's preprocessing steps. Now, my
> datasets are ready for the analysis stage. The I issue I have is only
> occurred with *one* of the participants where beta power has the highest
> value at 50 Hz in data.
> Is there any problem with this? I'm asking because I observed that some
> resources are considering that 50 Hz is a sign of the line noise in the
> electrode. I'm getting confused about this because I already performed the
> step of cleanLine in Makoto's preprocessing steps.
> Any advice will be highly appreciated.
> Eeglablist page: http://sccn.ucsd.edu/eeglab/eeglabmail.html
> To unsubscribe, send an empty email to
> eeglablist-unsubscribe at sccn.ucsd.edu
> For digest mode, send an email with the subject "set digest mime" to
> eeglablist-request at sccn.ucsd.edu
Swartz Center for Computational Neuroscience
Institute for Neural Computation, University of California San Diego
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the eeglablist