[Eeglablist] Using PACT - help

[Eric HG]

Thanks for your answer Makoto!

However, when I run the PACT using the GUI and the write eegh(), I do not
get any information about the code. Is there another way to get the code?

As far as I can see, the toolbox is only for continuous resting state data,
is that correct?

Furthermore, would you use the modulation index directly when comparing
groups or would it be appropriate to do some sort of normalization?

Thanks a lot!

Eric

On Wed, Nov 27, 2019 at 2:27 PM Eric HG <erichg2013 at gmail.com> wrote:

> Hi everyone,
>
> I've recently been trying to use the PACT toolbox created by Makoto. Here,
> I load a resting EEG (21 channels) into EEGLAB, and then click "Compute
> PAC". Here, the phase freq range is 30-45 Hz, the Amp freq range is 4-8,
> and the number of phase bins are 18 (according to previous literature).
>
> I was wondering where the PAC results are stored before statistical
> comparisons between groups?
>
> And if the results are actually normalized (as for example PAC/PACrandom)?
>
> Furthermore, is there an easy way to compute this from the command line?
>
> Best regards,
>
> Eric
>