[Eeglablist] Problem with fitting bilateral dipoles (Makoto's Preprocessing Pipeline)

[Makoto Miyakoshi]

Dear Mahjabeen,

> "found minimum after non-linear optimization for topography 1 on [-15.55
-16.7314 -71.9782; 15.55 -16.7314 -71.9782]

z == -72 is around nose or mouth. The ICA-derived scalp topography you used
should be wrong.

Makoto


On Thu, Mar 19, 2020 at 5:03 PM Mahjabeen Rahman <
mahjabeen.rahman at knights.ucf.edu> wrote:

>
> Hi everyone,
>
> I am getting the following message when I run fitbilateral dipole plugin.
> Is that something to worry about ? I am following the preprocessing
> pipeline by Makoto.
>
> "found minimum after non-linear optimization for topography 1 on [-15.55
> -16.7314 -71.9782; 15.55 -16.7314 -71.9782]
> the call to "ft_dipolefitting" took 3 seconds
> Fail to look up brain areas
> Done."
>
> The message "Fail to look up brain areas" also appeared when I ran DIPFIT
> (using autofit).
>
> Thanks in advance.
> Mahjabeen Rahman
> PhD Student
> Industrial Engineering & Management Systems
> University of Central Florida
>
> _______________________________________________
> Eeglablist page: http://sccn.ucsd.edu/eeglab/eeglabmail.html
> To unsubscribe, send an empty email to
> eeglablist-unsubscribe at sccn.ucsd.edu
> For digest mode, send an email with the subject "set digest mime" to
> eeglablist-request at sccn.ucsd.edu
>