[Eeglablist] ICA component rejection
mmiyakoshi at ucsd.edu
Fri Jul 24 11:46:32 PDT 2015
Sorry to tell you this but the 21 ICs are all noise.
I strongly recommend you perform preprocess again. Read this page and check
the steps. You may want to consider using PREP pipeline by Nima
Bigdely-Shamlo (described in the wiki).
Good ICs are determined by
1. Dipolarity of the IC scalp maps (see Delorme et al. 2012 PLoS One)
2. Frequency power spectrum of the ICs
3. ERP or ERSP (if available)
Note this kind of evaluation (or interpretaion) is dependent on the
Also, remember 'Garbage in, Garbege out'; if the experimental design is
screwed up, you don't get EEG even if you use the fanciest preprocessing
On Fri, Jul 24, 2015 at 6:38 AM, seetaramaraju jampana <
seetaramaraju.jampana at gmail.com> wrote:
> Hi ,
> How to reject ICA components by map. I mean to say , when the
> components maps are generated what are the areas to look out which suggest
> that the particular components has to be rejected.
> For Eg. the component map has been generated so which components are
> fit for rejection.The compononents maps link is
> Eeglablist page: http://sccn.ucsd.edu/eeglab/eeglabmail.html
> To unsubscribe, send an empty email to
> eeglablist-unsubscribe at sccn.ucsd.edu
> For digest mode, send an email with the subject "set digest mime" to
> eeglablist-request at sccn.ucsd.edu
Swartz Center for Computational Neuroscience
Institute for Neural Computation, University of California San Diego
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the eeglablist