[Eeglablist] newcrossf error
mmiyakoshi at ucsd.edu
Mon Jun 16 11:19:47 PDT 2014
If it works when you try it from GUI, then it should work if you try it
from the command line. Why don't you use the debug mode: type 'edit
newcrossf', put a breakpoint somewhere, maybe in line 275, run the function
from your command line, see the execution stops there, see what causes the
problem. It's even possible that the newcrossf() function you thought was
used is not even called...
On Mon, Jun 2, 2014 at 5:47 PM, <esantarn at bidmc.harvard.edu> wrote:
> Hi all,
> I'm trying to use newcrossf to calculate the phase coherence between two
> channels, this is what I get:
> Error in newcrossf (line 275)
> DEFAULT_ANGLEUNITS = 'deg'; % angle plotting units - 'ms' or 'deg'
> Output argument "R" (and maybe others) not assigned during call to
> If I lunch the crossf analysis using the GUI, it works perfectly. I tried
> both with epoched and continuous data, same result.
> Thanks a lot
> This message is intended for the use of the person(s) to whom it may be
> addressed. It may contain information that is privileged, confidential, or
> otherwise protected from disclosure under applicable law. If you are not
> the intended recipient, any dissemination, distribution, copying, or use of
> this information is prohibited. If you have received this message in error,
> please permanently delete it and immediately notify the sender. Thank you.
> Eeglablist page: http://sccn.ucsd.edu/eeglab/eeglabmail.html
> To unsubscribe, send an empty email to
> eeglablist-unsubscribe at sccn.ucsd.edu
> For digest mode, send an email with the subject "set digest mime" to
> eeglablist-request at sccn.ucsd.edu
Swartz Center for Computational Neuroscience
Institute for Neural Computation, University of California San Diego
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the eeglablist