[Eeglablist] Snapread error

Arnaud Delorme adelorme at ucsd.edu
Wed Feb 7 11:33:42 PST 2024


Dear Aliza,

Most likely you are getting this message because your file is truncated. I would check that the file was transferred or copy correctly or try to open it with a different tool.

Best wishes,

Arno

> On Feb 6, 2024, at 1:06 PM, Aliza Sloan via eeglablist <eeglablist at sccn.ucsd.edu> wrote:
> 
> I can open most of my Snapmaster files (.SMA) using EEGlab or using the snapread function in the Matlab command window, but one .sma file will not open. I am getting this error message: "File length does not match header information". See below.
> 
>  Number of channels:    32
>  Number of data points: 3688524
>  Sampling rate:         512.3 Hz
> ***> Note: File length does not match header information!
>            Difference: -3.09122e+06 frames
> 
> Any suggestions for ways to access this data?
> Thank you!
> 
> 
> 
> _______________________________________________
> Eeglablist page: http://sccn.ucsd.edu/eeglab/eeglabmail.html
> To unsubscribe, send an empty email to eeglablist-unsubscribe at sccn.ucsd.edu
> For digest mode, send an email with the subject "set digest mime" to eeglablist-request at sccn.ucsd.edu



More information about the eeglablist mailing list